The UTC018 is a 1000W Power Module for use in a MicroTCA chassis providing up to 800W output power. It is fully compliant with the MicroTCA.0 Revision 1.0 specification; including dual-redundant I2C buses (IPMB-0). The module is 12 HP, taking two full-size slots in a chassis. The UTC018 is hot-swappable and fully redundant when used in conjunction with a second module. Multiple temperature sensors are included on-board to monitor for over-temperature conditions within the unit. The current is continuously measured for each of the modules and reported to MCH for any faults. Once installed in the system, the firmware is upgradable via the Shelf Manager. The UTC018 can be configured to power and enable the modules without the presence of an MCH during development.

Key Features

ØDouble-module, 12HP size module per AMC.0

ØUniversal AC input (85 to 265V), 1000W

ØProvides power up to 12 AMCs, 2 MCHs and Cooling Units

ØVery low ripple voltage on +12 V

ØHot swappable with two banks of 256K flash for redundancy

ØDual IPMI bus

Ø32–bit RISC processor

ØBlue, red, amber and red LEDs

ØIPMI 2.0 and HPM.1 compliant

ØMenu driven software for ease of configuration

ØCurrent sensor per slot