The VadaTech UTC013 is a 792W power module (available in 396W) for use in a μTCA chassis. The power module runs at 95% efficiency when running at maximum load. This results in over 752W available to the system. It is fully compliant with the MicroTCA.0 revision 1.0 specification; including dual-redundant I2C buses (IPMB-0).

The UTC013 is hot-swappable and fully redundant when used in conjunction with a second instance of the module. It provides power to the twelve slots, two MCHs (MicroTCA Carrier Hubs) as well as the CUs (Cooling Units).

Multiple temperature sensors are included on-board to monitor for over-temp conditions within the module. The current is continuously measured for each of the modules and reported to MCH for any fault.

Once installed in the system the firmware is upgradable via the shelf manager. The UTC013 can be configured to power and enable the modules without the presence of an MCH.

• DC PSU for MicroTCA (792W)

• Very low ripple voltage

• Support for power module redundancy

• Efficient re-use of existing designs/components reduce costs

• Electrical, mechanical, software and system-level expertise in house

• Double-module, full-size module per AMC.0

• Dual DC input (–36V to –75V)

• 792W (available in 396W)

• Modules can be turned on without an MCH

• Available in UTCA.3 conduction cooled

• Two banks of 256K Flash for redundancy

• Hot swappable

• Dual IPMI bus

• 32–bit RISC processor

• Blue, red, amber and red LEDs

• IPMI 2.0 and HPM.1 compliant

• Menu driven software for ease of configuration

• Current sensor per slot

• External as well internal WDT