The VadaTech UTC011 is a 241/460W power module for use in a μTCA ATR chassis (Conduction Cooled chassis). The power module runs at 84% efficiency when running at maximum load. This results in 200/400W (available to the system). It is fully compliant with the MicroTCA.0 revision 1.0 specification; including dual-redundant I2C buses (IPMB-0).  

The UTC011 is fully redundant when used in conjunction with a second instance of the module. It provides power to the twelve slots, two MCHs (MicroTCA Carrier Hubs) as well as the CUs (Cooling Units, may not be present in the Conduction Cooled Chassis).Multiple temperature sensors are included on-board to monitor for over-temp conditions within the module. The current is continuously measured for each of the modules and reported to MCH for any fault. The firmware is upgradable via HPM.

• Wide array of power module options from VadaTech

• Design utilizes proven VadaTech subcomponents and engineering techniques

• Electrical, mechanical, software, and system-level
  expertise in house

• Single module, full size module per AMC.0

• Dual 10 to 36 VDC input for 241W option and 18 to 36 VDC input for 460W option

• Support for power module redundancy and dual IPMI bus

• 32-bit RISC processor

• Two banks of 256K flash for redundancy

• Field upgradable

• IPMI 2.0 and HPM.1 compliant

• Without the presence of an MCH the modules can be turned on

• Menu driven software for ease of configuration

• Current measure for each module

• External as well as internal WDT